Maintenance; Changing The Waste Collection Bag; Belt Adjustment - SEM 200 Operation And Maintenance Manual

6.) Maintenance

Before performing any service or maintenance on this machine, make certain to unplug the

6.1 Changing the Waste Collection Bag

Ensure that the power is off before attempting to change the waste collection bag located in the left
cabinet.
1. Open the door.
2. Reach inside and locate the snap ring around the inside rim.
3. Pull the tab on the snap ring inward and pull down with the bag to remove.
4. Place the snap ring over the top of the plastic bag and fold over the bag approximately three
inches.
5. Insert the snap ring with the waste collection bag into the bottom of the housing at an angle.
6. Pull down on the ring to make sure it seals in the rim of the housing.

6.2 Belt Adjustment

IMPORTANT: Belt should be checked and tightened if required after first two (2) days of operation.
After that, check monthly.
1. De-energize the unit by unplugging the unit.
2. Remove the top cover. Make sure to disconnect the grey connector before completely removing
the cover.
Important / Caution:
power cord from the receptacle.
11
semshred.com | 508.366.1488
Location of electrical
connection