6.3 IR remote control
Connect the IR receiver to the IR input connector (10). The IR remote control is used for signal switching
and can also be used to control source and display devices based on the CEC function.
Note:
•
The HDMI input 4 does not support CEC! Source devices connected to this input cannot be controlled
with the IR remote control.
•
The source and display devices must support CEC in order to control them with the IR remote control.
6.4 RS232 control
Connect the switch to the media control system with a RS232 cable and the supplied adapter and set the
parameters correctly. The control system can now control this switch via RS232 commands.
Baud rate: 9600
Data bit: 8
Stop bit: 1
Parity bit: none
5
21
INPUTS:
1-4: Select the appropriate input source.
MANUAL/AUTO:
Switch the automatic or manual mode.
SOURCE:
Controlling the input source (e. g. DVD-Player)
DISPLAY:
Display control (e. g. TV).
Tx GND Rx
RS232
1
9
6
Sub-D9
RS232 cable
RS232 socket
PC