Advertisement
Activating additional keys:
If you have purchased additional keys, they need to be installed on the switch. Complete the following
steps to install additional keys using the ISCLI interface.
1. To retrieve the key, navigate a browser to
sign in with your ID and password.
2. Click Request activation key.
3. Enter the authorization code. The authorization code was supplied to you by email or on paper
as part of the ordering process.
4. Click Continue and follow the instructions and download the key file.
5. Log on to the EN4093 switch with an SSH application. The default IP addresses for the switch
through the CMM are as follows: 192.168.70.120 (bay 1), 192.168.70.121 (bay 2),
192.168.70.122 (bay 3), 192.168.70.123 (bay 4). If necessary, obtain the IP address from your
system administrator.
6. Enter ena.
7. Enter software-key.
8. Enter enakey address <hostname or IP address> keyfile <file name>
protocol tftp mgt-port
Note: you must reset the switch to apply the key.
9. Reset the switch. Enter reload.
Repeat these steps for additional keys, if needed. The sequence of steps is shown here:
Router#ena
Router(config)#software-key
Router(Software-Key)#enakey address 9.44.143.206 keyfile
ibm_fod_0007_Y010CM28N001_anyos_noarch.key protocol tftp mgt-port
Starting download key file...
Key file download complete (494 bytes)
Software feature 'Upgrade1' will be Active upon next reboot.
Aug
5 11:47:39 1080:0:0:0:0:0:0:82 NOTICE
will be Active upon next reboot.
A Reboot is required for the new settings to take effect.
Router(Software-Key)#reload
...
Resetting at 11:47:59 Tue Aug
https://www.ibm.com/systems/x/fod/index.wss
mgmt: Software feature 'Upgrade1'
5, 2014...
and
Page 2 of 2
Advertisement
