Table of Contents
Advertisement
3.8.2.9
ABS indicator lamp
Only applies to S pedelecs with this equipment
The ABS indicator lamp must light up after the
system has started up and must go out once
speed has reached about 5 km/h. If the ABS
indicator lamp does not light up when the electric
drive system starts, the ABS is defective. An error
code on the display also tells the rider that it is
defective.
:
Figure 18: ABS error message on the Kiox display
If the indicator lamp does not go out after you set
off or it lights up while you are riding, this means
there is an error in the ABS. The ABS is then no
longer active. The brake system itself will continue
to work. It is only the ABS control which no longer
works.
If the ABS indicator lamp is lit, the ABS function is
not active.
Notice
The ABS indicator lamp may light up if the front
and rear wheels are rotating at widely different
speeds from one another – for example, if the
rider manoeuvres on the rear wheel only or if a
wheel is rotating for a unusually long time without
making contact with the ground (fitting stand).
The ABS will switch off at such times.
Stop the S pedelec, switch off and restart to
reactivate the anti-blocking system.
MY20K10 - 12_1.0_11.01.2021
3.8.3
Operating element
The on-board computer is operated using six
buttons on the control panel.
5
Figure 19: Operating element overview
Symbol
Designation
<
1
Back button
2
Select button
>
3
Forward button
+
4
Plus button
5
Push assist button
6
–
Minus button
Table 23: Operating element overview
Overview
4
3
2
1
6
29
Advertisement
Table of Contents
