Advertisement
POWE R UP
1. Remove the round Battery Cover and insert 1 AA battery into the
Center Battery Compartment. Optional: Insert batteries into the Extra
Battery Compartments. IMPORTANT: Be sure all batteries are of the
same voltage level.
2. The hands will move to the 4, 8, or 12 o'clock position and stay there
while it searches for the WWVB Atomic Time Signal. Allow up to 5
nights for the clock to receive this transmission.
3. For the best reception, place the clock on an exterior wall near a
window with the front or back of it facing Fort Collins, CO.
4. Once the Atomic Time Signal is received, the clock will set to Pacific
Time. Firmly press and hold your correct Time Zone Button until the
hands begin to spin. The time will then set correctly.
5. If you live in an area that does not follow Daylight Saving Time, while
the hands are spinning to the correct time, press the Daylight Saving
Time Button once to turn the DST setting to OFF.
Watch the setup video:
bit.ly/wallclock_setup
Note: In certain areas, this clock may not be able to receive the WWVB
reception due to signal strength or interference. In this case, your clock
can be set manually until the Atomic Time Signal can be received.
MA NUA L LY SE T T IME
1. Remove all batteries from the clock.
2. Press the Manual Set Tab at least 20 times and wait 15 minutes.
3. Insert at least one battery into the Center Battery Compartment.
4. Allow the hands to spin around and stop in either the 4, 8, or 12
o'clock position.
5. Hold the Manual Set Tab until your correct time is achieved.
Note: The Atomic Time Signal will override your manual setting if the
transmission is received in the future.
Page | 2
+
5
1
A
A
2
-
3
PT
MT
CT
ET
Thermometer/Hygrometer
• Your thermometer and hygrometer have been pre-calibrated and
should not need adjustment.
• Before manually adjusting your sensors, allow the clock to sit at room
temperature for 2 hours.
• To manually adjust your sensors, gently turn the temperature or
humidity sensor adjustment on the back of the clock until desired
setting is reached.
LET'S BE S OCIAL!
Ask questions, watch detailed setup videos, and provide feedback on
our social media outlets!
SPEC IFICATIONS
Battery Requirements: 1 AA (IEC LR6) required in movement
Optional: 2 AA (IEC LR6) for added battery life
All batteries sold separately.
Battery Life: 1 Battery - 12 months, 3 Batteries - 36 months
Temperature Range: -40°F to 140°F Humidity Range: 0% to 100% RH
1
Manual Set Tab
+
Center Battery
2
Time Zone Buttons
3
5
Daylight Saving Time Button
4
(Default is DST ON)
Optional:
5
-
4
Extra Battery Compartments
Page | 3
Advertisement
