Advertisement
Rail Height and Width Adjustments Instructions
1. To adjust the height or width of either the Low or High Rail, first loosen the turnbuckles.
Low or High Rail Height Adjustment
2. Choosing the desired Low or High Rail Adjusting Bracket, loosen the Locking handle on the long
adjusting Tube and while supporting the rail pull the Snap Lock and move the rails to the desired
location. Let the Snap Lock, snap into a hole on the adjusting tube and tighten the Locking Handle to
secure it in place. (Fig. 12)
Rail Width Adjustment
3. Only the Low Rail Adjusting Bracket can be adjusted to change the width between the Rails, loosen
the Locking handle on the Horizontal Adjusting Tube and while supporting the rail pull the Snap
Lock and move the rail to the desired location. Let the Snap Lock, snap into a hole on the adjusting
tube and tighten the Locking Handle to secure it in place. (Fig. 12)
4. Always retighten the 4 turnbuckles equally so that the apparatus uprights remain perpendicular to
the floor. Also check the alignment of the 2 uprights in comparison to each other.
Note: DO NOT tighten Turnbuckles to the point that the cables are taught or springy! This
WILL NOT make the bars work better! It will only add pressure to the connecting
points. If the cables are over-tightened, twisting of the Cantilever Uprights may occur
which will make height adjustment of rails more difficult and may result in permanent
damage to the Uprights
Ensure all Clamps, Snap Locks and Locking Handles
are fully engaged prior to using the Equipment, this
also applies to the Base Uprights Spin-Snap Locks.
Never add any padding or tape
to the bar surfaces.
365 / Instruction #8920101 Rev 4
SNAP LOCK
LOCKING HANDLE
Pg. 9
BASE UPRIGHTS
SPIN-SNAP LOCK
Fig. 12
Advertisement
