Advertisement
Cantilever Bars Assembly Instructions
Note: There is a top & left / right
side to this Assembly so ensure
that the Locking Devices and
Adjustment Holes in the Tubes
face the same direction as
shown in Figure 6.
1. First slide the High Rail Adjusting
Brackets and then the Low Rail Adjusting
Brackets over each of the Long Adjusting
Tubes to the appropriate heights.
2. Ensure that both Left and Right Hand
Cantilever Upright Bars each have a set of
Adjusting Brackets at the same height and
that the Snap locks are fully engaged and
that the Locking Handles are also
Tightened. (Fig. 6)
3. Next insert the Short Adjusting Tubes into
the Low adjusting bracket as shown in
Figure 6.
4. Ensure that the Snap locks are fully
engaged and that the Locking Handles are
also Tightened on the Horizontal
Adjusting Tubes. (Fig. 6)
Note: Do not insert assembled Cantilever Upright Assemblies into uprights at this point in
the assembly process. Follow each assembly step in sequence.
JFK Upright Assembly (355-05) to Base Leg Assembly (355-01)
The following procedures will require at
least two (2) qualified persons. Children or
other unqualified personnel should at no
time undertake any part of this procedure.
5. Now locate the two (2) JFK Base Leg Assembly
and the JFK Upright Assembly.
6. Align the Base Legs with the numbers on the
sides facing away from the center. Install the
uprights as shown in Figure 7 & 8 so that the
upright is centered with the Number "0".
365 / Instruction #8920101 Rev 4
CANTILEVER BAR UPRIGHT
(Long Adjusting Tube)
HIGH RAIL
ADJUSTING BRACKET
LOW RAIL
ADJUSTING BRACKET
LOCKING DEVICES
BASE LEG
Fig 7
Pg. 5
LOCKING DEVICES
HORIZONTAL
ADJUSTING TUBE
Fig. 6
Fig. 6
UPRIGHT
ASSEMBLIES
Advertisement
