Advertisement
Section II
Pre-Assembly Instruction for Collapsible JFK Uprights (355-05)
Note:
This step must be done first, before any further Assembly of your Apparatus! Ensure the
screws are tightened securely!
1.
Locate the two Upright Ends (355-312), a Base Tube and
the 7/32" Allen key.
2.
Slide the Base Tube over the connection block with the hole
facing upwards as shown. Line up the holes and thread the
supplied 3/8" Flat Head Screw into the hole. Tighten screw
firmly with a 7/32" Allen key. (Fig. 1)
3.
Repeat previous step to assemble the other upright to the
base tube. The resulting assembly is now referred to as a
JFK Upright Assembly Part #355-05. (Fig. 2)
4.
Ensure the assembly is stable before proceeding.
Note: Refer to the subsequent sections in this "JFK"
Cantilever Assembly literature for complete details
on Tie-down, Base fastening and assembly of all
other related components for this Just For Kids
Apparatus.
365 / Instruction #8920101 Rev 4
Assembly, Set-Up and Adjustments
Fig. 2 – Uprights and Base Tube Assembled
Pg. 4
UPRIGHT END
BASE TUBE
3/8" FLAT
HEAD SCREW
CONNECTION BLOCK
Fig. 1
Advertisement
