Surge Hopper - Bayer HealthCare SeedGrowth CBT Series Maintenance Manual

SUrgE HoPPEr

Warning! Exercise extreme caution when working
with dust and chemicals! Refer to the Exposure
Control Guide at the end of the manual, page 21. Wear
proper personal protective equipment: goggles, a face
respirator, chemical resistant gloves and coveralls.
Dust Evacuation Port
Step 1: Use a slot screwdriver to loosen and remove the hose from
the dust evacuation port.
Step 2:
Use a vacuum to clean build-up from inside the hose and
the dust evacuation port opening. When finished cleaning, replace
the hose on the dust evacuation port and tighten in place with a slot
screwdriver.
SUrgE HoPPEr
HI/lo Sensor Kit
Step 1: Check the signal cables for wear.
Disconnect signal cables from control panel.
Use a nut driver to remove/replace the HI/LO
sensor kit, if needed.
Step 2: Replace the HI/LO sensor kit and
tighten in place with a nut driver. Connect
signal cables to the control panel.
required maintenance tools
• S crewdriver (slot)
• N ut driver
• 7 /16", 1/2" and 10mm socket heads
• V acuum
• P utty knife
5