Package Contents - Grandstream Networks GWN7600 Quick Installation Manual

EN
OVERVIEW
The GWN7600 is a mid-tier 802.11ac Wave-2 WiFi access point for small
to medium sized businesses, multiple floor offices, commercial locations
and branch offices. It offers dual-band 2x2:2 MU-MIMO with beam-form-
ing technology and a sophisticated antenna design for maximum network
throughput and expanded Wi-Fi coverage range. To ensure easy instal-
lation and management, the GWN7600 uses a controller-less distributed
network management design in which the controller is embedded within
the product's web user interface. This allows each access point to man-
age a network of up to 30 GWN76xx series APs independently without
needing separate controller hardware/software and without a single point-
of-failure. This wireless access point can be paired with any third party
routers as well as Grandstream GWN series routers. With support for
advanced QoS, low-latency real-time applications, 450+ concurrent client
devices per AP and dual Gigabit network ports with PoE, the GWN7600
is an ideal WiFi access point for medium wireless network deployments
with medium-to-high user density.
PRECAUTIONS
• Do not attempt to open, disassemble, or modify the device.
• Do not expose this device to temperatures outside range of 0 °C to
50 °C for operating and -10 °C to 60 °C for storage.
• Do not expose the GWN7600 to environments outside of the follow-
ing humidity range: 10-90% RH (non-condensing).
• Do not power cycle your GWN7600 during system boot up or firm-
ware upgrade. You may corrupt firmware images and cause the unit
to malfunction.

PACKAGE CONTENTS

GWN7600 Access Point
3 x Screw
(PM 3.0 x 50)
1x Ceiling Mounting
1x Mounting Bracket
Bracket
3 x
3 x Screw
Plastic Expansion Bolt
(PA 3.5 x 20 )
~1~
1 x Quick Installation Guide
3 x M3 NUT
1 x GPL Statement
GWN7600 PORTS
Port Description
POWER Power adapter connector (DC24V, 1A)
Note: Power adapter is not provided.
NET/POE Ethernet RJ45 port (10/100/1000Mbps) support-
ing PoE.
NET Ethernet RJ45 port (10/100/1000Mbps) to your
router or another GWN76xx.
USB 2.0 port (for future IOT & location based ap-
plications)
RESET Factory reset button. Press for 7 seconds to reset
factory default settings.
POWERING AND CONNECTING THE GWN7600
GWN7600 can be powered on using PoE switch using following steps:
Step 1: Plug a RJ45 Ethernet cable into the network port of the
GWN7600
Step 2: Plug the other end into the uplink port of the power over Ether-
net (PoE) switch.
Network Port
RJ45 Ethernet Cable
to Power over Ethernet
(PoE) Switch
~2~