Removing Roll Paper - Epson SC-P9500 Series User Manual

SC-P9500 Series/SC-P7500 Series User's Guide
c
Important:
The commercially available media types, such as
those shown below, may not be cut cleanly by the
built-in cutter. Furthermore, cutting the following
media types may damage or reduce the lifetime of
the built-in cutter.
❏ Fine art paper
❏ Canvas
❏ Vinyl
❏ Matte poster board
❏ Adhesive paper
❏ Banner media
Cut these media types with commercially available
scissors or a cutter in the following manner:
With the front cover closed, hold down the X -
Forward buttons on the control panel while viewing
the inside of the printer until the cutting position
emerges from below the front cover. Cut the paper
using scissors or a third-party cutter.
Setting Auto Cut
You can specify the method either on the control panel
or the printer driver. Note, however, that the setting
selected with the printer driver takes priority when the
printer driver is used.
Note:
❏ Disable the auto cut settings in the printer and the
printer driver when using the optional auto take-up
reel unit.
❏ It may take a while to cut the roll paper.
Setting on the computer
Set Auto Cut from the Roll Paper Option in the printer
driver's Properties (or Printing preferences) screen.
Setting from the printer
Set this in General Settings - Printer Settings - Paper
Source Settings - Roll Paper Setup - Cut Settings -
Auto Cut from the control panel.
Basic Operations
Manual cut method
When Off is selected in the printer driver or Off is
selected for Auto Cut in the control panel, the paper can
be cut in any location after printing as described below.
A
With the front cover closed, hold down the X -
Forward or Backward button on the control
panel while viewing the inside of the printer until
the cutting position reaches the position of the
label.
Note:
To cut the paper using the built-in cutter, the
distance from the cutting position to the edge of the
paper needs to be 60 to 127 mm. The necessary
length differs depending on the paper type and
cannot be changed. If the necessary length has not
been reached, paper is fed automatically leaving a
margin. Use a commercially available cutter to
remove the unnecessary margin.
B
Touch Cut.
A confirmation screen is displayed. Press the Cut
button to cut using the built-in cutter.

Removing Roll Paper

This section describes how to remove and store roll
paper after printing. The pressure roller may leave
impressions on paper that is left in the printer.
26