Epson SC-P9500 Series User Manual page 42

SC-P9500 Series/SC-P7500 Series User's Guide
Caution:
Removing paper from the auto take-up reel unit
requires two workers, one on each end of the roll.
A single worker working by his or herself could drop
the roll, resulting in injury.
A
Set the auto take-up reel unit Auto switch to Off.
B
Cut the paper and take it up until it is all on the
auto take-up reel unit roll core.
When Take-up After Cut is set to ON
Paper is automatically wound up after cutting.
When cutting, make sure you support the paper
by hand so that the printed surface does not
touch the floor. If you cannot take-up all the
paper, flip the Auto switch to Off if necessary,
and then continue taking up using the Manual
switch.
When Take-up After Cut is set to Off
Paper is not automatically wound up after
cutting.
Follow the steps below to cut the paper while
supporting it with your hands so that the printed
surface does not touch the floor, and then
take-up the paper manually.
(1) Flip the Auto switch to Off.
Basic Operations
(2) Cut the paper.
(3) Keep the Manual switch pressed in the take-up
direction (either Forward or Backward).
"Manual cut method" on page 26
U
C
Unlock the movable unit and remove it from the
roll core.
When removing the movable unit, support the
roll core with one hand to prevent it falling to the
floor.
D
Remove the roll core from the auto take-up reel
unit.
42