Cleaning The Printer; Cleaning The Outside; Cleaning The Inside - Epson SC-P9500 Series User Manual

SC-P9500 Series/SC-P7500 Series User's Guide
G
Install the new cutter.
Insert a screw into the cutter side of the hole on
the printer.
H
Tighten the screw with a cross-head screwdriver
to secure the cutter.
c
Important:
Screw the cutter firmly, otherwise the cut
position may be slightly shifted or skewed.
I
Insert the base of the cutter replacement cover in
the correct place, and push in the top part.
Push until you hear it click into place.
J
After replacing the cutter, press the Z button.
The cutter will return to its original position.
Cutter replacement is complete when the screen
on the control panel returns to the screen
displayed before you started replacement.
Maintenance

Cleaning the Printer

To keep your printer in optimum operating condition,
clean it regularly (about once a month).

Cleaning the outside

A
Remove any paper from the printer.
B
Make sure the printer is turned off and the screen
has turned off, and then unplug the power cable
from the outlet.
C
Use a soft, clean cloth to carefully remove any
dust or dirt.
To prevent dust from accumulating, be sure to
clean the following areas on the back and sides.
(In the following image, the optional Adobe
PostScript 3 expansion unit is installed.)
If the printer is particularly dirty, dampen the
cloth with water containing a small amount of
neutral detergent, and then firmly wring the
cloth dry before using it to wipe the printer's
surface. Next, use a dry cloth to wipe away any
remaining moisture.
c
Important:
Never use benzene, thinners, or alcohol to
clean the printer. They could cause
discoloration and deformities.

Cleaning the inside

Clean the pressure rollers if prints are smudged or
soiled.
126