Chain Lubrication; Chain Free-Movement Inspection - Triumph Speed Triple S Owner's Handbook Manual

Chain Lubrication

Lubrication is necessary every 200 miles
and also after riding in wet weather, on
wet roads, or any time that the chain
appears dry.
Use the special chain lubricant as
recommended in the
section.
Apply lubricant to the sides of the rollers
then allow the motorcycle to stand
unused for at least
(overnight is ideal). This will allow the oil
to penetrate to the chain O-rings etc.
Before riding, wipe off any excess oil.
If the chain is especially dirty, clean first
and then apply oil as mentioned above.
Caution
Do not use a pressure washer to clean
the chain as this may cause damage
to the chain components.
Maintenance and Adjustment

Chain Free-Movement Inspection

Specification
eight hours
1. Maximum movement position
Before starting work, make sure that
the motorcycle
adequately supported. This will help
prevent injury to the operator or
damage to the motorcycle.
Place the motorcycle on a level surface
and hold it in an upright position with no
weight on it.
Rotate the rear wheel by pushing the
motorcycle to find the position where
the chain is tightest, and measure the
vertical movement of the chain midway
between the sprockets.
The vertical movement of the drive chain
must be
(21 - 30 mm).
1
Warning
is stabilized and
in the range 0.8 - 1.2 in
101