Warnings - Qsonica Sonicator Q500 Operation Manual

2. WARNINGS

Please read the manual in its entirety. Necessary instruction and guidance are provided to help
ensure the successful operation of this device. Observe the following:
 High voltage is present in the power supply, converter and high frequency cable. There are no user-serviceable
parts inside any of these devices. Do NOT attempt to remove the power supply cover or converter case.
 Do NOT touch any open cable connections on the unit while the power is turned ON.
 Do NOT operate power supply with converter disconnected from high voltage cable. High voltage is present in the
cable and may pose a shock hazard.
 Do NOT attempt to disconnect the converter high voltage cable while the unit is running.
 The power supply must be properly grounded with a 3-prong plug. Test electrical outlet for proper grounding
before plugging in unit.
 Install the ultrasonic processor in an area free from excessive dust, dirt, explosive or corrosive fumes and
protected from extremes in temperature and humidity. Do not place the power supply within a Fume Hood.
 Hearing protection is highly recommended. It is recommended that a sound abating enclosure or ear protection be
used when operating the Ultrasonic Processor.
 NEVER immerse the converter in liquids of any kind, or let condensed moisture or liquid drip into the converter.
 NEVER grasp an activated horn or probe. It can cause severe burns and tissue damage.
 NEVER allow a probe to vibrate in air.
 NEVER hold or clamp the converter by the front driver or by the horn itself. This can cause permanent damage to
the system. Support the converter by only clamping around the converter housing (upper portion).
If needed air cool the converter with dry compressed air.

 Do NOT allow the tip of a vibrating horn or probe to touch the counter top or any other hard surface. It could
damage the probe, overload the power supply, or damage the surface.
 Avoid touching the bottom or sides of a glass or plastic container with an activated probe. It could crack or shatter
the glass or melt the plastic.
 Turn OFF the power switch, unplug the power supply and disconnect the power cord from the back of the power
supply before attempting to replace the fuses.
Inspect high frequency cable for cracks in the protective outer jacket.

 Do not operate unit with a damaged cable. Doing so may cause serious injury.
 In case of AC power loss, wait 3 minutes minimum before reapplying power.
 Do not turn off AC mains power while running a horn. Stop sonication via touch screen prior to stopping power.
Symbols
Caution, Risk of electric shock, Hazardous voltage
Caution, Risk of danger. Refer to User Manual.
Page 5 of 30