Procedure To Configure Dynamic Dns; Figure 3-6 Configure Dynamic Dns - ZyXEL Communications Prestige 791R User Manual

Prestige 791R G.SHDSL Router
FIELD
Domain Name
Edit Dynamic DNS
Route IP
Bridge

3.5.3 Procedure to Configure Dynamic DNS

If you have a private WAN IP address, then you cannot use Dynamic DNS.
Step 1. To configure Dynamic DNS, go to Menu 1 — General Setup and select Yes in the Edit
Dynamic DNS field. Press [ENTER] to display Menu 1.1— Configure Dynamic DNS as
shown next.
Follow the instructions in the next table to configure Dynamic DNS parameters.
3-10
Enter the domain name (if you know it) here. If you leave this field
blank, the ISP may assign a domain name via DHCP. You can go to
menu 24.8 and type "sys domainname" to see the current domain
name used by your gateway.
If you want to clear this field just press the [SPACE BAR]. The domain
name entered by you is given priority over the ISP assigned domain
name.
Press the [SPACE BAR] to select Yes or No (default). Select Yes to
configure Menu 1.1 — Configure Dynamic DNS (discussed next).
Set this field to Yes to enable or No to disable IP routing. You must
enable IP routing for Internet access.
Turn on/off bridging for protocols not supported (for example, SNA) or
not turned on in the previous Route IP field. Select Yes to turn
bridging on; select No to turn bridging off.
Menu 1.1 - Configure Dynamic DNS
Service Provider = WWW.DynDNS.ORG
Active= Yes
Host= me.ddns.org
EMAIL= mail@mailserver
USER= username
Password= *********
Enable Wildcard= No
Press ENTER to confirm or ESC to cancel:

Figure 3-6 Configure Dynamic DNS

DESCRIPTION EXAMPLE
zyxel.com.tw
No
Yes
No
Initial Setup