Table of Contents
Advertisement
19.7 Setup wizard
You can restart the setup wizard (Setup wizard) at any
time by proceeding as follows:
19.8 Info
• To have the radio display current information about
its hardware and software (version numbers, device
designation, radio ID, etc.), proceed as follows:
• If you have already registered your radio
on the online portal of Frontier Silicon
(http://www.wifiradio-frontier.com), then
you can find out the radio ID there, as well.
[ ]
System settings
Setup wizard
[ ]
System settings
Info
38
19.9 Backlight
Brightness sensor activated
• Move the sliding switch (10) to the ON position.
• The brightness of the display is now automatically
adjusted according to the ambient brightness.
Brightness sensor deactivated
• Move the sliding switch (10) to the OFF position.
The backlight can be confi gured for each operating
mode (Operation Mode, Standby Mode, Slumber Mode)
separately.
Proceed as follows:
• For the operation modes Operation Mode and
Slumber mode, select between various brightness
levels.
• For Standby Mode, you may also choose a brightness
level for the backlight when the radio is in standby
(Standby Level). Alternatively, you can set the backlight
to turn off completely in standby (Standby Level
Off).
• Choose a time interval for Timeout. When the radio is
in standby, press [ENTER/NAVIGATE] to illuminate the
display at the brightness level set for that operating
mode for the selected interval of time.
• Alternatively, you can disable this feature (Timeout
Off).
Alternatively, press [
] on the remote control to directly
adjust the backlight setting for the current operating mode.
[ ]
System settings
Backlight
Advertisement
Table of Contents
