Setting Up Your Computer's Ip Address; Windows 2000/Nt/Xp - ZyXEL Communications Prestige 652H/HW Compact Manual

LED COLOR
AUX Orange
Green
DSL Green
ACT/PPP Orange
Green

3 Setting Up Your Computer's IP Address

Skip this section if your computer is already set up to accept a dynamic IP
address. This is the default for most new computers.
The Prestige is already set up to assign your computer an IP address. Use this section to set up your
computer to receive an IP address or assign it a static IP address in the 192.168.1.2 to 192.168.1.254
range with a subnet mask of 255.255.255.0. This is necessary to ensure that your computer can
communicate with your Prestige.
Your computer must have an Ethernet card and TCP/IP installed. TCP/IP should already be installed
on computers using Windows NT/2000/XP, Macintosh OS 7 and later operating systems.

3.1 Windows 2000/NT/XP

1. In Windows XP, click start, Control Panel. In Windows 2000/NT, click Start, Settings, Control Panel.
2. In Windows XP, click Network Connections.
In Windows 2000/NT, click Network and Dial-up Connections.
3. Right-click Local Area Connection and then click Properties.
4. Select Internet Protocol (TCP/IP) (under the General tab in Win XP) and click Properties.
Prestige 652H/HW
Table 2 Front Panel LED Description
STATUS
On The CON/AUX port has a dial-up connection.
Off The CON/AUX port does not have a dial-up connection.
On The CON/AUX port has a console connection.
Off The CON/AUX port does not have a console connection.
On The Prestige is linked successfully to a DSLAM.
Blinking The Prestige is initializing the DSL line.
Off The DSL link is down.
On The Prestige has a PPP (PPPoA or PPPoE) connection.
Blinking The Prestige is sending/receiving PPPoA or PPPoE traffic.
Off The system is ready, but is not sending/receiving data.
Blinking The Prestige is sending/receiving non-PPP traffic.
DESCRIPTION
6