Table of Contents
Advertisement
LABEL
CON/AUX
Only connect this port if you want to configure the Prestige using the SMT via console port or
switch
set up a backup WAN connection; see your User's Guide for details.
CON/AUX port
Set this switch to the "CON" side to use the CON/AUX port as a console port for local device
configuration and management. Connect the 9-pin male end of the console cable to the console
port of the Prestige and the other end to a serial port (COM1, COM2 or other COM port) on your
computer. Your computer should have a terminal emulation communications program (such as
HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow
control and 9600 bps port speed.
Set this switch to the "AUX" side to use the CON/AUX port as an auxiliary dial-up WAN
connection. Use the included CON/AUX converter, with the console cable to connect the
CON/AUX port to your modem or TA.
RESET
You only need to use this button if you've forgotten the Prestige's password. It returns the
Prestige to the factory defaults (password is 1234, LAN IP address 192.168.1.1 etc.; see your
User's Guide for details).
2.2 Inserting a PCMCIA Wireless LAN Card
Use a ZyAIR series wireless LAN PCMCIA card to add optional wireless LAN capabilities.
Step 1.
Turn off the Prestige.
Never insert or remove a wireless LAN card when the Prestige is turned on.
Step 2.
Locate the slot labeled Wireless LAN on the Prestige.
Step 3.
With its pin connector facing the slot and the LED side facing upwards, slide the ZyAIR
wireless LAN card into the slot.
Never force, bend or twist the wireless LAN card into the slot.
Step 4.
Turn on the Prestige. The WLAN LED should turn on.
2.3 The Front Panel LEDs
Prestige 652H/HW
Table 1 Prestige Rear Panel Description
DESCRIPTION
4
Advertisement
Table of Contents
