Table of Contents
Advertisement
13.1 Remote Node Setup Overview
This section describes the protocol-independent parameters for a remote node. A remote node is required
for placing calls to a remote gateway. A remote node represents both the remote gateway and the network
behind it across a WAN connection. When you use menu 4 to set up Internet access, you are configuring
one of the remote nodes.
You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that node's profile in
menu 11.1, as well as configure specific settings in three submenus: edit IP and bridge options in menu
11.3; edit ATM options in menu 11.6; and edit filter sets in menu 11.5.
13.2 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
13.2.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1.
From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
Step 2.
When menu 11 appears, as shown in the following figure, type the number of the remote node
that you want to configure.
Remote Node Configuration
Remote Node Configuration
This chapter covers remote node configuration.
Prestige 645R-A Series User's Guide
Chapter 13
13-1
Advertisement
Table of Contents
Troubleshooting
