Using The Appliance - ECG TV 20 Operating Manual

EN
DESCRIPTION
1. Power control
2. Temperature control
3. Air vent cover
4. ON indicator light
Precautions against injury by electric shock shall only be taken if the device is turned off by thermostat,
heat switch or disconnected from power source.
Requirements on installation
Place the hot air ventilator on a flat surface with a sufficient amount of space around the appliance to
ensure the proper function of exhaust vents. The distance between the device and the closest
wall must be at least 1 m.

USING THE APPLIANCE

This hot air ventilator uses hot air technology with temperature regulation. Turn the power control to
set the required level:
= OFF
= ventilator
I = low 1200 W
II = high 2400 W
The red indicator light indicates the hot air ventilator has been turned on.
1. Turn the temperature control clockwise to the maximum level.
2. Upon achieving the desired room temperature, turn the temperature control counter clockwise
until you hear a soft click and the temperature is set. The hot air ventilator and indicator light is
turned off.
3. The device now monitors the temperature set. As soon as the room temperature drops, the hot air
ventilator will automatically switch on and after reaching the desired room temperature, will again
automatically switch off.
3
2
1
4
16