ZyXEL Communications Prestige 128IMH User Manual page 77

Numbers
Route
Bridge
Edit PPP Options
Rem IP Addr
Edit IP/IPX/Bridge Options
Telco Options:
Allocated Budget
(min)
Period (hr)
Transfer Type
Nailed-up Connection
Remote Node Configuration
If the Primary Phone number is busy or does not answer,
your Prestige will dial the Secondary Phone number if
available.
Some areas require dialing the pound sign # before the
phone number for local calls. A # symbol may be included
at the beginning of the phone numbers as required.
This fields determines the protocols that your Prestige will
route.
Bridging is used for protocols that the Prestige doe not
support, e.g., SNA, or not turned on in the previous Route
field. When bridging is enabled, your Prestige will forward
any packet that it does not route to this remote node;
otherwise, the packets are discarded. .
To edit the PPP options for this remote node, move the
cursor to this field, use the space bar to select Yes and
press [Enter]. This will bring you to Menu 11.2 - Remote
Node PPP Options. For more information on configuring
PPP options, see the section Editing PPP Options.
This is a required field [?] if Route is set to IP. Enter the
IP address of the remote gateway.
To edit the parameters, select Yes and press [Enter]. This
will bring you to Menu 11.3 - Remote Node Network Layer
Options. For more information on this screen, refer to the
chapter pertaining to your specific protocol.
This field sets a ceiling for outgoing call time for this
remote node. The default for this field is 0 for no budget
control.
This field sets the time interval to reset the above
outgoing call budget control.
This field specifies the type of connection between the
Prestige and this remote node. When set to Leased, the
Allocated Budget and Period do not apply.
This field specifies if you want to make the connection to
this remote node a nailed-up connection. See below for
more details.
Prestige 128IMH ISDN Modem/ Router/Hub
Press space
bar to toggle
Yes/No
Press space
bar to toggle
Yes then press
[Enter]
Press space
bar to toggle
Yes then press
[Enter]
Default = 0
64k/Modem/
Leased
Yes/No
4-5