How To Enable Gas Consumption Metering; How To Add Bookmarks - Suunto EON CORE 2.0 User Manual

Suunto EON Core
Within each view of the mode, you can define what information is shown in customizable
fields. When editing the view in DM5, you get a preview of how it will look on your Suunto
EON Core.
In each view, you can define switchable fields on the screen. In the selected view, you can
cycle through these values by pushing the lower button. These customizable data fields are
different from each other depending on the layout selected (classic, graphical or prominent).
Use DM5 to customize these fields and learn more.

4.8. How to enable gas consumption metering

When you customize your Suunto EON Core in DM5 to include the gas consumption info field
in the switch window (see 3.9. Customize dive modes with DM5), this information will always
be avalable and visible during a dive where you use the gas to which the Tank POD is
attached.
TIP: Make sure the tank size is correct.
To enable gas consumption
1. Add the gas consumption filed to your custom dive mode in DM5. See 3.9. Customize dive
modes with DM5.
2. Install and pair a Suunto Tank POD. See 4.5. How to install and pair a Suunto Tank POD.
3. After you have selected the correct gas and returned to the main time view, keep the
middle button pressed to enter menu.
4. Scroll to Gases with the lower button and select with the middle button.
5. Scroll to the gas you just selected from your Tank POD and select with the middle button.
6. Scroll to Tank size and select with the middle button.
7. Check the tank size and change the size with the upper or lower button as needed.
Confirm change with the middle button.
8. Keep the middle button pressed to exit the menu.
NOTE: For accurate gas consumption, you must define the tank size. Not defining the
tank size leads to incorrect gas consumption readings.

4.9. How to add bookmarks

While diving, keep the lower button pressed to add a bookmark (timestamp) to the active log
for later reference.
Bookmarks save the following info: time stamp, depth, temperature, pressure if tank pod is
used. Data can be seen in DM5 after the dive.
If you keep the lower button pressed while the compass view is active, both a timestamp and
the current compass heading are stored to the active log.
NOTE: In compass view pressing down button long will lock the bearing.
49