Table of Contents
Advertisement
Prestige 660RU-Tx Series User's Guide
30.8 Problems with the Web Configurator
Table 81 Troubleshooting the Web Configurator
PROBLEM
I cannot access
the web
configurator.
30.9 Problems with Remote Management
Table 82 Troubleshooting Remote Management
PROBLEM
I cannot remotely
manage the
Prestige from the
LAN or WAN.
245
CORRECTIVE ACTION
Refer to the Quick Start Guide for hardware connections.
Make sure that there is not an SMT console session running.
Check that you have enabled web service access. If you have configured a secured
client IP address, your computer's IP address must match it. Refer to the chapter on
remote management for details.
For WAN access, you must configure remote management to allow server access
from the Wan (or all). Refer to the chapters on remote management for details.
Your computer's and the Prestige's IP addresses must be on the same subnet for
LAN access.
If you changed the Prestige's LAN IP address, then enter the new one as the URL.
Remove any filters in SMT menu 3.1 (LAN) or menu 11.5 (WAN) that block web
service.
See also
the Problems with Remote Management
CORRECTIVE ACTION
Refer to
the Remote Management Limitations section
Management Configuration
possible.
Use the Prestige's WAN IP address when configuring from the WAN.
Use the Prestige's LAN IP address when configuring from the LAN.
Refer to for instructions on checking your LAN connection.
Refer to
the Problems with the LAN Interface section
your WAN connection.
See also
the Problems with the Web Configurator
section.
in
for scenarios when remote management may not be
for instructions on checking
section.
Chapter 30 Troubleshooting
Chapter 10 Remote
Advertisement
Table of Contents
Troubleshooting
