Detailed Work-Flow Procedures On A Computer; Exposure - MallinCam HD-10 II User Manual

Mallincam HD-10 II User Manual

Detailed Work-Flow Procedures on a Computer

This section describes the typical procedures in imaging using a computer. For a more
detailed explanation of each control see the section HD-10 II Control Software below.
Once you have the HD-10 II's Mallincam Software up and running, you should see an image
of whatever the HD-10 II camera is looking at (at whatever exposure setting the software is
set at).
At the Top of the Window on the Status Bar, ensure that the Capture tab is selected.

Exposure

Step 1
The first thing you should do (until you become more
familiar with the operation of the Camera) is to turn on
the Auto Exposure. The Mallincam Software provides a
simple process of selecting and deselecting the
autofocus along with the ability to manually adjust the
exposure settings.
The Mallincam HD-10 II has an exposure range from 1 ms to 10 seconds
To activate the Auto-Exposure, just check the box next to its name. This will gray out the
manual adjustments, Exposure Time slider and the gain slider.
You can set a preferred value for the exposure setting using the Target slider located under
the Auto Exposure checkbox.
You have two ways to manually adjust the exposure (make sure Auto Exposure is
unchecked):
1. By using the Manual entry values.
You can enter in a value in the s and ms boxes or use the up and down arrows adjacent
to the box to increase or decrease the value in the box.
Click on the OK button accept the new exposure value.
HD-10 II User Manual
March 30, 2020
Page 24