ZyXEL Communications ZyXEL ZyAIR G-3000 Quick Start Manual page 7

LED COLOR
BDG/RPT Red
Green
ZyAIR Blue
WLAN
Green
ETHN
Green
Orange
SYS
Green
Orange
PWR
Green
Red
ZyAIR G-3000 Quick Start Guide
Table 1 ZyAIR Front Panel LED Description
STATUS
Blinking The ZyAIR is not ready or is rebooting in AP+Bridge or
Bridge/Repeater mode.
The ZyAIR has a successful reboot in AP+Bridge or
Off
Bridge/Repeater mode.
On The ZyAIR is set up as an AP+Bridge or Bridge/Repeater.
Off The ZyAIR is set up as an Access Point.
Blinking ZyAIR is sending/receiving data through the wireless LAN.
(Breathing)
On The ZyAIR is ready, but is not sending/receiving data.
Off The LED has been disabled in the web configurator or SMT.
Off Neither of the WLAN interfaces is communicating successfully with
another device.
On Both or one of the WLAN interfaces is communicating successfully
with another device.
Blinking TX/RX packets are being sent through the ZyAIR.
Off The Ethernet connection is not ready, or has failed.
On The ZyAIR has a successful 10Mbps Ethernet connection.
Blinking The ZyAIR is sending/receiving data.
On The ZyAIR has a successful 100Mbps Ethernet connection.
Blinking The ZyAIR is sending/receiving data.
Off The ZyAIR is not receiving power.
On The ZyAIR is receiving power.
Blinking The ZyAIR is receiving power but is not ready.
On The ZyAIR is receiving low power.
Off The ZyAIR is not receiving power.
On The ZyAIR is receiving power.
On The ZyAIR is receiving power over the Ethernet cable.
DESCRIPTION
7