ZyXEL Communications ZyXEL ZyAIR G-3000 Quick Start Manual page 18

1. Connect the screw (included) to the support holder.
2. Connect the support holder to the ZyAIR but do not tighten the screw.
3. Twist the support holder to the side.
4. Run the connection wires through the gap in the support holder
5. Twist the support holder back to the vertical position and tighten the screw that connects the
support holder to the ZyAIR.
Wall-mounted
Follow the steps to attach your ZyAIR to a wall.
1. Locate a high position on the wall that is free of obstructions.
2. Connect two screws (not included) in the wall 80mm apart. You can use the diagram at the end of
this guide to help you mark the screw holes correctly. Use screws with 6mm ~ 8mm (0.24" ~
0.31") wide heads.
ZyAIR G-3000 Quick Start Guide
Figure 9 Support Holder Connections
Figure 10 Support Holder Connection Pass Through
18