Loose Parts List - Ryobi P552 Operator's Manual

The following items are included with your compound miter saw:
 Dust Bag
 Work Clamp
AAA BATTERIES
WARNING:
The use of attachments or accessories not listed might be hazardous and could cause serious personal injury.
UNPACKING
This product requires assembly.
 Carefully lift miter saw base from the carton by the "D"
handle and the saw base, and place it on a level work
surface.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.

LOOSE PARTS LIST

 Blade Wrench
 Rear Bracket/Carrying Handle
DUST
BAG
REAR BRACKET/
CARRYING HANDLE
ASSEMBLY
 This saw has been shipped with the saw arm secured in
the down position. To release the saw arm, push down
on the top of the saw arm, cut the tie-wrap, and pull out
the lock pin.
WARNING:
The saw arm is spring loaded. Hold the handle down
to prevent from snapping up when cutting the tie-wrap.
Failure to do so could result in possible serious injury.
 Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the tie wrap.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
11 – English
 2 (AAA) Batteries
 Operator's Manual
CLAMP
BLADE
WRENCH
WORK
Fig. 5