Tools Needed - Ryobi P552 Operator's Manual

FEATURES
SELF-RETRACTING LOWER BLADE GUARD
SWITCH
See Figure 3.
LOCK
The lower blade guard is made of shock-resistant, see-
through plastic that provides protection from each side of
the blade. It retracts over the upper blade guard as the saw
SWITCH
is lowered into the workpiece.
TRIGGER
SPINDLE LOCK BUTTON
See Figure 3.
The spindle lock button locks the spindle, stopping the
blade from rotating. Depress and hold the lock button while
installing, changing, or removing the blade.
SPINDLE
SWITCH TRIGGER
LOCK BUTTON
See Figure 3.
LOWER BLADE
The saw will not start until you depress the switch lock with
GUARD
your thumb then squeeze the switch trigger. To prevent
unauthorized use of the compound miter saw, remove the
battery pack from the tool and lock the switch in the off
position. To lock the switch, install a padlock (not included)
through the hole in the switch trigger and make certain the
switch is inoperable. If the switch is still operable with the
padlock installed, a padlock with a larger shackle diameter
must be used. Store the padlock key in another location.
SWITCH
TRIGGER
PADLOCK
Fig. 3

TOOLS NEEDED

The following tools (not included) are needed for making adjustments:
COMBINATION SQUARE
FRAMING SQUARE
Fig. 4
10 – English