Further Functions - Kärcher SensoTimer ST6 eco!ogic Manual

reparation / teaching sensor 2*
* depending on model
Figure 11
The setting process of sensor 2 starts
automatically after the atering setting
of ater outlet 1. If the ater outlet 1 re-
mains inactive, teaching of the ater
outlet 2 must be enabled by pressing
the OK button. The seconds countdo n
starts for ater outlet 2. Teaching of
sensor 2 is e uivalent to sensor 1.
ote: In order to change the operating
mode of an outlet or to add a sensor, the
teaching process must be restarted.
Remove the batteries from both sen-
sors and the control unit.
Reinsert the battery in the control unit.
As soon as the symbols appear on the
display, press the OK button until the
time on the display is flashing.
Reset the time and start the teaching
process of sensor 1, then of sensor 2.
Irrigation settings of water outlet 2
Identical ith irrigation settings of a-
ter outlet 1 .

Further functions

Changing the settings of the water
outlets
The menu button activates the settings
mode.
Arro keys select the ater outlet to be
set, OK button starts the adjustment
cycle.
The settings remain saved even ithout
battery supply.
Manual irrigation of the water
outlets
Valves can be opened manually:
The menu button activates the settings
mode.
Use the arro keys to select the tap and
confirm your selection ith the OK but-
ton.
The valves are opened/closed by re-
peatedly pressing the arro keys.
The esc button terminates the manual
irrigation and s itches back into the au-
tomatic mode.
uick access manual watering
Can be activated in every mode (auto-
matic atering and 24h-function).
Hold the left arro key do n for at least
3 seconds in order to open the left valve
manually.
Depending on the scope of delivery, the
same procedure ith the right arro
key applies to open the right valve.
The valve is open.
Press the left/right arro key briefly in
order to close the opened valve or to
open it again.
If both valves are closed, the device au-
tomatically returns to the previous
mode after 30 seconds.
Terminate the manual atering by
means of the OK button or esc/menu
button. The valve is closed and s itch-
es back into the automatic mode.
Failure safety function
If the valve unit loses contact to a sen-
sor (no signal as, for example, the sen-
sor battery is empty), the atering is
time-controlled.
ote
ECO delay days are considered.
Advantage: Guarantee of continuous
atering, plants do not dry out.
EN – 5 15