Advertisement
Attention Installer: Please be sure this instruction sheet and warranty information are left with the customer when installation is complete.
USING THE SYSTEM
1. Pull hose handle out, down and away from the valve.
2. Continue pulling the hose until you feel the end of the hose reach the valve. You will hear and feel the hose end
"click" into its locked position. Turn the system on using the on/off switch inside the valve.
3. Begin vacuuming. The system can be used to vacuum dry messes. Optional attachments may be used on the hose
end to meet various cleaning needs.
1
STORING THE HOSE
1. With the system on, unlock the hose by grabbing it approximately 8-inches from the valve and rotate the hose to
the left until it releases.
2. Partially cover the handle end with hand to retract the hose.
3. Once fully retracted, push the handle end onto the rubber ball and the system will automatically turn off.
1
H-P Products, Inc. • 512 W. Gorgas St., Louisville, Ohio 44641 • www.chameleonvac.com • 80205-01 • 10/20
OPERATING INSTRUCTIONS
2
2
3
On/Off
Switch
3
Advertisement
Table of Contents
Related Manuals for H-P Products Chameleon
Summary of Contents for H-P Products Chameleon
- Page 1 2. Partially cover the handle end with hand to retract the hose. 3. Once fully retracted, push the handle end onto the rubber ball and the system will automatically turn off. H-P Products, Inc. • 512 W. Gorgas St., Louisville, Ohio 44641 • www.chameleonvac.com • 80205-01 • 10/20...
- Page 2 (3) years from original date of consumer purchase. In the event of a defect in the Chameleon Hose, it will be repaired or replaced, at H-P Products’ option, at an Authorized Dealer’s location at no cost to you.
Need help?
Do you have a question about the Chameleon and is the answer not in the manual?
Questions and answers