Installation On A Gearbox; Completing Installation - Bosch Rexroth 70 Series Instruction Manual

30/56 Installation
For attachment via gear
wheel or helical gear shaft
Bosch Rexroth AG, A2FM/A2FE/A2FMT Series 70, RE 91071-01-B/06.2018
8. Make sure that no excessive axial and radial forces are acting on the drive shaft.
9.
Details on the required tools and tightening torques for the mounting bolts are
available from the machine/system manufacturer.
10. When using flexible clutches, check that the drive is free of resonance after
completing the installation.

7.4.5 Installation on a gearbox

The following describes how to install the axial piston unit on a gearbox.
After installing on a gearbox, the axial piston unit is covered and is difficult to access:
▶ Before installing, make sure that the spigot diameter centers the axial piston unit
(observe tolerances) and that no excessive axial or radial forces are acting on the
drive shaft of the axial piston unit (installation length).
▶ Protect the drive shaft against frictional corrosion by providing permanent
lubrication.
▶ Fasten the axial piston unit at the installation location.
No gearing forces higher than the maximum permissible axial and radial forces
should act on the shaft; if necessary, support the gear wheel at the gearbox output
separately.

7.4.6 Completing installation

1. Remove any installed transport screws.
CAUTIOn! Operation with protective plugs!
Operating the axial piston unit with protective plugs may result in injury or damage
to the axial piston unit.
▶ Before commissioning, remove all protective plugs and replace them with suitable,
pressure-resistant, metal threaded plugs or connect the appropriate lines.
2. Remove the transport protection.
The axial piston unit comes with protective covers (1) and protection plugs (2).
They are not pressure-resistant and have to be removed prior to connection. Use
a suitable tool for this to prevent damage to the sealing and functional surfaces.
If sealing or functional surfaces are damaged, contact your Bosch Rexroth service
partner or the service department of the factory that manufactured the axial
piston unit.