Troubleshooting - Zoom RhythmTrak RT-123 Operation Manual

Check the following items first if there seems to be a problem with the RT-123.
Symptom
No sound or
very low volume.
Sound is distorted or
intermittent.
Song cannot be
recorded.
FS01 has no effect.
Simultaneous
playback with MIDI
components is not
possible.
56

Troubleshooting

Check
Is supplied AC adapter connected
properly?
Is [OUTPUT] jack connected
correctly to the playback system?
Is there a problem with the shielded
cable?
Is the connected playback system
operating normally?
Is volume of RT-123 set correctly?
Is output level of RT-123 set too
high?
Is RT-123 set to mode other than
song mode?
Is memory capacity limit reached?
Is FS01 connected correctly to
[FOOT SW] jack?
Is desired function of FS01
activated?
Is the MIDI receive function set to
ON?
Remedy
Connect AC adapter as described in
"Getting Connected" (page 7). Use only the
supplied AC adapter.
Make connections as described in "Getting
Connected" (page 7).
Try using another cable.
Check the system and make sure that the
volume level is adjusted properly.
Set [VOLUME] control to a suitable
position.
Set [VOLUME] control of RT-123 to a
suitable position.
Activate song mode (page 34).
Delete unneeded patterns and songs.
Make connections as described in "Getting
Connected" (page 7).
Use [FUNCTION] key and pad 9 (FOOT
SW) to select function ( p. 47).
Use the [FUNCTION] key and pad 13
(MIDI) to change the setting from "Int"
(MIDI clock receive disabled) to "Midi"
(MIDI clock receive enabled).