Troubleshooting - Zoom MRT-3 Operation Manual

Check the following items first if there seems to be a problem with the MRT-3.
No sound or very low volume.
• Is the [POWER] switch set to ON?
Turn power on, as described in the section
"Preparations" (page 8).
• Is [OUTPUT] jack connected correctly
to the playback system?
Make connections as described in "Getting
Connected" (page 7).
• Is there a problem with the shielded
cable?
Try using another cable.
• Is the connected playback system
operating normally and is the volume
setting appropriate?
Check the system and make sure that the
level is adjusted properly.
• Is [OUTPUT LEVEL] control of MRT-3
set correctly?
Set the control to a suitable position.
Sound is distorted or intermittent.
• Is output level of MRT-3 set too
high?
Set [OUTPUT LEVEL] control of MRT-3
to a suitable position.
Cannot record pattern.
• Is MRT-3 set to mode other than
pattern mode?
Activate pattern mode ( ➝ p. 14).
• Is memory capacity limit reached?
Check remaining memory capacity( ➝ p.
39), and delete unneeded patterns and
songs.
50
MRT-3
ZOOM

Troubleshooting

Song cannot be recorded.
• Is MRT-3 set to mode other than
song mode?
Activate song mode ( ➝ p. 33).
• Is memory capacity limit reached?
Check remaining memory capacity( ➝ p.
39), and delete unneeded patterns and
songs.
Playback sound is not in stereo.
• Is Y cable connected to [OUTPUT
STEREO/PHONES] jack?
Make connections as described in "Getting
Connected" (page 7).
• Is the panning setting appropriate?
Check whether the pan parameter for the
instrument sounds in the currently used kit
is set properly ( ➝ p. 28).
FS01 has no effect.
• Is foot switch connected correctly to
the [FOOT SW] jack?
Make connections as described in "Getting
Connected" ( ➝ page 7)
• Is correct function selected for
FS01?
Use [FUNCTION] key and pad 4 (FOOT
SW) to select the proper setting ( ➝ p. 42).