Moving To A Desired Point In The Song (Locate Function); Playing Back The Same Passage Repeatedly (A-B Repeat Function) - Zoom HD16 Operation Manual

Moving to a desired point in
the song (locate function)
You can specify a location within the song in time units
(minutes/seconds/milliseconds) or in measure units (measure/
beat/tick) units, and move to that location.
PRJ 1 PRJ 1 PRJ001 PRJ001
Ó00 000:00:000 00 000:00:000
Minutes Seconds
Select with cursor up/down keys
PRJ 1 PRJ 1 PRJ001 PRJ001
Ó00 000-00-000 00 000-00-000
Measures Beats Ticks
1.
Verify that the transport is stopped and the
main screen is shown.
The locate function can only be used when the transport is
stopped.
2.
Use the cursor left/right keys to move the
flashing part to the unit to change.
The unit that can be changed is indicated by the flashing value.
PRJ 1 PRJ 1
Ó00 000:00:000 00 000:00:000
You can use the cursor up/down keys to switch between time
indication and measure/beat/tick indication.
3.
Turn the dial to change the value.
When you change the displayed value, the recorder
immediately moves to the new location. Pressing the PLAY
[R] key starts playback from that point.
HINT
If you have set marks using the marker function (
can use the locate function to move among the marks.
ZOOM HD8/HD16
Milliseconds
PRJ001 PRJ001
→
p. 47), you
Playing back the same
passage repeatedly
(A-B repeat function)
A-B repeat is a function that repeatedly plays back a desired
section of the song. This is useful to listen to the same section
repeatedly, for example during practice.
1.
Move to the point where repeat playback
should begin, and press the [A-B REPEAT]
key in the control section.
The key flashes, and the repeat start location (point A) is
specified.
HINT
The A/B point can be specified either during playback or when
the recorder is stopped.
2.
Move to the point at which repeat playback
should end, and press the [A-B REPEAT] key
once more.
The [A-B REPEAT] key will change from flashing to
constantly lit, and the repeat end location (point B) is set.
NOTE
If you specify a point B that is located earlier than point A, the
→
section from points B A will be played repeatedly.
3.
To redo the A/B point setting, press the [A-B
REPEAT] key so that it goes out, and then
repeat the procedure from step 1.
4.
To begin repeat playback, press the PLAY [
key.
When point B is reached, the recorder jumps back to point A,
and playback continues.
5.
To stop repeat playback, press the STOP [
key.
Even after pressing the STOP [P] key to stop playback, you
can perform repeat playback again as many times as desired,
as long as the [A-B REPEAT] key is still lit.
6.
To turn off repeat playback, press the [A-B
REPEAT] key.
The key goes out, and repeat playback will be turned off. The
A/B point locations also will be cleared.
Reference [Recorder]
R
]
P
]
39