Samson EXPEDITION XP106 Owner's Manual page 14

Quick Start - Stage XPD1 Wireless System
5. If the transmitter and receiver have not been
previously paired, press and hold the button
on the RXD1 receiver for >5 seconds, until it
begins to flash.
6.
Press and hold the Power button on the belt
pack transmitter >5 seconds. This will put
both components into pairing modes. Once the
receiver and transmitter communicate and sync,
the LEDs on both units will light steady and will
be ready for operation.
7. Speak or sing into the mic at a normal
performance level and raise the WIRELESS
LEVEL control until the desired level is reached.
If you hear distortion check the rear panel PEAK LED. If it is lit red, turn down the
WIRELESS LEVEL on the XP106 until it lights only occasionally during loud sounds. If you
still hear distortion, open the battery compartment and use the supplied plastic screwdriver
to turn the Gain control in the PXD1 transmitter slowly counterclockwise until the distortion
disappears.
Conversely, if you hear a weak, noisy signal at the desired volume level (and with the
WIRELESS control of the XP106 turned fully clockwise), use the supplied plastic
screwdriver to turn the Gain control in the PXD1 transmitter slowly clockwise until the
signal reaches an acceptable level.
14