Table of Contents
Advertisement
Available languages
Available languages
Dimming LED lighting:
When the LED lighting has been switched on, it
can be dimmed by keeping key ④ pressed.
Ambient lighting
Press the on/off button for 3 seconds and the
ambiant lighting will start.
Programming the remote control
The remote control for hood and hob are pre-
installed and ready for use. Only when te remote
control needs to be reprogrammed (interaction
with other controls)act as in the following.
Determine the code used:
a. Simultaneously press
The lamp flashes as well as the selected code
(there are 10 code options in total) (figure 1).
Change the code:
a. Simultaneously press
for 3 seconds until the lamp is flashing. After
this the lamp as well as the selected code will
flash. Repeat this step until you have reached
the required code (there are 10 code options in
total) (figure 1).
b. Simultaneously press
green speed indicator lamp is blinking (figure 2).
c. Press the
key on the remote control within
10 seconds to confirm the settings. The cooker
hood and the remote control are now in line with
each other (figure 3).
Change the batteries:
• For changing the batteries unscrew the plastic
cover, remove the old batteries and insert the
new ones. Pay attention to the polarity marking
given in the battery compartment (figure 4).
• Empty batteries are not to be disposed of in the
household refuse, but they are to be handed in
as chemical waste.
NOVY key:
• You can switch on the ambient lighting using
the NOVY key (figure 5).
Technical information:
- Power supply: (2xAAA) batteries
- Frequence: 433.92Mhz
- Numbre of codes: 10
- Worktemperature: 0-50°C
- Dimensions: 110 x 50 x 19mm
on/off +
the key .
on/off +
the key
+
until the second
1
2
Maintenance
Maintenance of the grease filter
The hood contains one metal filter which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don't reset, the LED lights will continu blinking.We
advise you to clean your filter twice a month for an
optimal operation.
Access to the filter
Take hold of the right and left side of the plate (a)
and pull down simultaneously.
Remove the filter (b) by taking hold of its hook and
pulling down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a liquid
detergent. Rinse and allow to dry completely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the recirculation filter
The cooker hood has a Monoblock recirculation
filter. Only use the Novy Monoblock recirculation
filter in the cooker hood.
Cleaning indication:
The red LED will light up after 200 working hours
(time to regenerate the Monoblock recirculation
filter). The recirculation filter is to be found behind
the grease filter.
3
4
5
EN 19
Advertisement
Table of Contents
