Remote Control; Maintenance - Novy Cloud 230 Operating And Installation Instructions

3.3 Remote control

The remote control for hood is preinstalled and ready
for use.
If the power is disconnected from the unit and
switched on again, wait 3 minutes before using
the remote control. This prevents the code from
being changed so that the unit does not respond
to the remote control or so that another unit is not
connected to the remote control.
If the set code disrupts other transmitters, another
code can be selected using the remote control.
There are 10 different codes in total.
Change the code
• First switch off the power supply of the hood. Do this
by deactivating and reactivating the on/off switch.
The set-up mode will now be active for 3 minutes.
The new code must be set up within these 3 min-
utes.
• Simultaneously press
mote control flashes as many times as the selected
code. Repeat this step until you have reached the
required code (there are 10 code options in total).
• Press the key on the remote control within 10 sec-
onds to confirm the settings. The cookerhood and
the remote control are now in line with each other.
Change the batteries
• For changing the batteries unscrew the plastic cov-
er, remove the old batteries and insert the new ones.
Pay attention to the polarity marking given in the
battery compartment (figure 4).
• Empty batteries are not to be disposed of in the
household refuse, but they are to be handed in as
chemical waste.
Technical information:
- Power supply: (2xAAA) batteries
- Frequence: 433.92Mhz
- Numbre of codes: 10
- Worktemperature: 0-50°C
- Dimensions: 110 x 50 x 19mm
and . The lamp on the re-
3.4 InTouch
The cooker hood features the InTouch function. If you
have a Novy induction plate with InTouch, you can op-
erate the hood from the plate.
Programming InTouch on the induction plate
The remote control must first work with the hood. If
necessary, the remote control code can be changed,
as described in Section 3.3.
Connect the plate to the mains supply.
1. Press buttons and
taneously for 10 seconds until you hear 5 consecu-
tive bleeps.
• The cooker plate now searches automatically for
the hood code
• WAIT until the hood lights flash, OR until you hear
a clicking sound eight times from the hood (be
patient, this can take a while)
2. Then touch any InTouch key
on the induction plate plate until you hear a beep
signal. This is the confirmation of the pairing of both
devices.
Now you can operate the hood with the keys on the
induction plate.

4. Maintenance

4.1. Grease filter
In the hood there are 2 round metal grease filters. The
cooker hood has a cleaning indicator for the grease
filters.
Grease filter indication
Indication: green indicator lamp starts
burning.
After 400 cooking hours, an green lamp on the hood
indicates that the grease filter needs cleaning
Access to the filter
Open the bottom plate by pulling it open on the front
side with 2 hands in a downward movement.
on the induction hob simul-
or or or
EN 19