Daily Use - Washing & Drying - Electrolux WTSL 4 E200 User Manual

24 www.electrolux.com
If you set the time value of
only 10 minutes, the
appliance performs only a
cooling phase.
10.4 At the end of the drying
programme
1. The appliance stops automatically.
2. The acoustic signals operate (if they
are active).
3. In the display
4. The indicator of button Start/Pause -
Départ/Pause goes off.
5. The last minutes of the drying cycle
the appliance performs the anti-crease
phase.
The anti-crease symbol
The door is still locked (the symbol
is on).
11. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
11.1 NON-STOP programme
WARNING!
Do not put a plastic device/
ball for the detergent into the
drum.
1. Press button Ein/Aus - Marche/Arrêt
for some seconds to activate the
appliance .
2. Load the laundry one item at a time.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the symbols of the different
washing phases.
5. Set the available options.
WARNING!
Do not set a spin speed
lower than the automatic
speed of the set programme.
comes on.
flashes.
6. Press button Ein/Aus - Marche/Arrêt
for some seconds to deactivate the
appliance.
After some minutes from
the end of the
programme, the energy
saving function
automatically deactivates
the appliance.
7. When the door locked light
off you can open the door.
8. Remove the laundry from the
appliance. Make sure that the drum is
empty.
9. Keep the door ajar, to prevent mildew
and odours.
10. Close the water tap.
11.2 Washing and Drying at
automatic levels
1. Press button Trockengrad - Niveau de
séchage repeatedly until the black line
appears under one of the dryness
level symbol.
The iron dry level
The cupboard dry level
The extra dry level
The drying symbol comes on.
The anti-crease symbol comes on.
The display shows that the appliance is
ready to start.
The time value on the display is the
duration of both cycles washing and
drying, calculated on a default load
size.
goes