Related Manuals for Sanus BXL1
Summary of Contents for Sanus BXL1
- Page 1 GET IT RIGHT THE FIRST TIME BXL 1 Follow this step-by-step instruction manual to INSTRUCTION MANUAL speed up your installation. Para Español ver página 24...
- Page 2 Call us at: Watch it now at: Check it out at: 800-359-5520 SANUS.com/2760 SANUS.com/1172 Or, chat at: SANUS.com/chatSP Milestone AV Technologies and its a liated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions, or variations.
- Page 3 (including accessories) Yes — This mount is NOT compatible. 130 lbs. 180 lbs. Solid Concrete or Stud Walls weigh more Visit MountFinder.Sanus.com or call 1-800-359-5520 (58.9 kg) (81.6 kg) Concrete Block Walls than to find a compatible mount. Drywall Solid concrete...
- Page 4 Before you begin Don’t stress out Remove the stand Install any accessories when you see from your TV all the hardware included. — if attached. you may have purchased — if they require the TV to be removed from the Extra TV screw sizes and lengths wall for assembly.
- Page 5 Step-by-Step illustrations Read ALL CAUTION Protect the face warnings. of your TV speed up your installation. when laying it down for installation. These are IMPORTANT! Don’t get it? Read the detailed explanation below each step. CAUTION: Avoid potential ASSEMBLE Soft clean surface Read Important Stuff read read rea Must Read read read read read read Read read read Safety First read re...
- Page 6 STEP 1 Attach TV Bracket to TV WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
- Page 7 1.1 Select TV Screws 1.2 Determine Spacer Need TV Bracket TV Bracket Flat Back Cables Round Back Inset Holes TV Bracket TV Bracket TV Bracket Too Short Correct Too Long For flat-back TVs, no For rounded-back TVs, cable interference or CAUTION: spacers inset holes, spacers...
- Page 8 1.3 Attach TV Bracket Assembly to TV POSITION SECURELY TIGHTEN Flat-back TVs Rounded-back TVs / Extra Space The release cords R TV brackets should be 13 14 TIP: oriented on the bottom on the TV. Install using the spacer, screw and washer combination you Center the TV brackets over your TV's mounting hole selected for your TV.
- Page 9 STEP 2 Attach Wall Plate to Wall WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used.
- Page 10 STEP 2A Wood Stud Installation CAUTION: Avoid potential Min. 1 ½ in. (3.8 cm) personal injury or property damage! ● Drywall covering the wall Min. 16 in. (40.6 cm) Min. 3 ½ in. (8.9 cm) must not exceed 5/8 in. (1.5 cm) ●...
- Page 11 CAUTION: Be sure you drill into the CENTER of the stud. TIP: our HeightFinder at sanus.com [www.sanus.com/1172]. Place the wall plate template at your desired height and position the Drill the four pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
- Page 12 STEP 2A (continued) REMOVE TEMPLATE SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! Improper use could reduce the holding power of the screws DO NOT over-tighten the screws Install the four screws and tighten only until they are pulled Remove the wall plate template and discard.
- Page 13 Minimum horizontal space between fasteners: 16 in. (40.6 cm) Min. 16 in. (40.6 cm) To calculate your precise wall plate location, check out TIP: TIP: our HeightFinder at sanus.com [www.sanus.com/1172]. Position the wall plate template on the wall at your desired height. Level and mark the hole locations.
- Page 14 STEP 2B (continued) DRILL REMOVE TEMPLATE 3 in. (7.6 cm) 3/8 in. (10 mm) CAUTION: CAUTION: Never drill into the mortar between blocks. Never drill into the mortar between blocks. Drill four pilot holes using a 3/8 in. (10 mm) diameter drill bit. Remove the wall plate template and discard.
- Page 15 INSERT ANCHORS SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! Improper use could reduce the holding power of the screws Be sure the anchors are seated flush CAUTION: CAUTION: DO NOT over-tighten the screws with the concrete surface. Insert four anchors into the drilled holes.
- Page 16 Steel Stud Installations (kit required) STEP 2C Steel Stud Installation Kit (NOT INCLUDED) CAUTION: Avoid potential personal injury or property damage! Min. 16 in. (40.6 cm) ● Studs must be at least 2x4 / 25 ga. 1/4-20 x 1 ¾ in. ●...
- Page 17 CAUTION: Be sure you drill into the CENTER of the stud. TIP: our HeightFinder at sanus.com [www.sanus.com/1172]. Drill the four pilot holes using a 1/2 in. (13 mm) diameter drill bit. Place the wall plate template at your desired height and position the IMPORTANT: Pilot holes must be drilled to a depth of 1 in.
- Page 18 STEP 2C (continued) INSTALL ANCHORS SECURELY TIGHTEN CAUTION: Avoid potential personal injury or property damage! All four screws MUST BE firmly tightened to prevent unwanted CAUTION: Be sure cap movement of the wall plate . Ensure the wall plate is securely seated against the drywall surface.
- Page 19 STEP 3 Attach TV to Wall Plate HANG ATTACH HEAVY! You may need assistance 02 01 with this step. CAUTION: Avoid potential personal injury or property damage! Always make sure TV brackets are in the locked position so the TV is securely fastened to the wall plate Press the bottom of the TV into the wall plate until you hear TV brackets...
- Page 20 Adjustments LEVEL HEIGHT...
- Page 21 TV LATERAL SHIFT REMOVING THE TV HEAVY! You may need HEAVY! You may need assistance with this step. assistance with this step. CAUTION: Avoid potential personal injury or property damage! NOTE: To rehang the TV, follow the procedures in STEP 3 on PAGE 16. Slowly slide the TV along the wall plate to reposition.
- Page 22 Troubleshooting If you are uncertain about your hardware selection, contact Customer Service at 1-800-359-5520. TV supplied spacers : Use your TV supplied spacer/adapter for flat back TVs : Use your TV supplied spacer/adapter and spacer for: (AND you want your TV closer to the wall). ●...
- Page 23 Dimensions in. [mm] TV INTERFACE TOP VIEW - EXTENDED 27.17 [690.0] FOR SMALL PARTS PANEL 16.73 [425.0] 9.50 17.53 7.87 [241.3] [445.3] [200.0] WALL PLATE 24.00 23.62 [609.6] 30.00 [600.0] [762.0] 17.72 [450.0] 16.00 0.33 [406.4] [8.4] 7.00 SIDE VIEW [177.8] 1"...
- Page 24 En paredes Sí. Este soporte NO es compatible. (incluidos los 81,6 kg hormigón sólido o con montantes 58,9 kg Visite MountFinder.Sanus.com o llame al 1-800-359-5520 pesa bloques de hormigón de acero accesorios) (180 lb) (130 lb) para encontrar un soporte compatible.
- Page 25 Español ¡ESTAMOS AQUÍ PARA AYUDARLE! ¿Desea ver un video para comprobar lo fácil que es hacerlo usted mismo? Visualícelo ahora en: SANUS.com/2760 Acierte a la primera. HeightFinder™ le indica el lugar donde debe taladrar. Descúbralo en: SANUS.com/1172 Nuestros expertos en instalación de EE. UU. están listos para ayudar.
- Page 26 Español PASO 1 Fijar el soporte del televisor al televisor PÁGINA 6 ADVERTENCIA: Este producto contiene piezas pequeñas que, en caso de ser tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones.
- Page 27 COLOCAR LA PLANTILLA CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta HeightFinder disponible en sanus.com [www.san.us/1172]. Coloque la plantilla de la placa mural a la altura que desee y ubique los orificios muescados sobre las líneas centrales del montante. Nivele y marque la ubicación de los orificios.
- Page 28 COLOCAR LA PLANTILLA CONSEJO: ara calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta HeightFinder disponible en sanus.com [www.san.us/1172]. Coloque la plantilla de la placa mural en la pared a la altura que desee. Nivele y marque la ubicación de los orificios.
- Page 29 COLOCAR LA PLANTILLA CONSEJO: Para calcular la ubicación concreta de la placa mural, pruebe nuestra herramienta HeightFinder disponible en sanus.com [www.san.us/1172]. Coloque la plantilla de la placa mural a la altura que desee y ubique los orificios muescados sobre las líneas centrales del montante. Nivele y marque la ubicación de los orificios.
- Page 30 Español PASO 3 Fijar el televisor en la placa mural PÁGINA 19 CUELGUE EL TELEVISOR EN LA PLACA MURAL PRECAUCIÓN: Evite posibles lesiones físicas y daños materiales. Para APLICACIONES EN HORMIGÓN: Los soportes de televisor DEBEN estar centrados en la placa mural NOTA: Para APLICACIONES SOBRE MONTANTES DE MADERA, los soportes de televisor se pueden deslizar a cualquier parte de la placa...
- Page 31 Español Solución de problemas PÁGINA 22 Use el separador proporcionado para televisores con partes traseras planas (o bien si quiere que su televisor esté más cerca de la pared). Use el separador proporcionado con el televisor y el separador para: televisores con la parte trasera redondeada (irregular) o si necesita espacio adicional para los cables.
- Page 32 800-359-5520 • info@sanus.com • SANUS.com SANUS • 6436 City West Parkway • Eden Prairie, MN 55344 USA ©2018 Milestone AV Technologies. All rights reserved. SANUS is a division of Milestone. 6901-602272 00 All other brand names or marks are used for identification purposes and are trademarks of their respective owners.