Factory Default; Fcc Regulation - EcoSmart A9A19A60WESDZR1 Use And Care Manual

Factory Default

□
To reset the remote (B), insert the reset pin (D) into the reset button pin hole (GG) and hold for
three seconds. This will reset the remote without removing the battery cover (JJ).
□
To reset the LED bulb (A), ip the power switch on and off six times within 5 seconds.
Low Power Noti cation and Replacing the Battery
□
The indicator light (AA) will blink twice fast indicating that the battery is low.
□
To replace the battery, remove the battery cover (JJ) with a screwdriver.
□
Use a at head screwdriver to remove the battery (HH) and replace with a new 3V CR2450 battery (HH).
□
Replace the battery cover (JJ) on the remote (B) and tighten the screws (II).
NOTE: Battery will weaken with age and should be replaced before leaking takes place as this will damage
the remote. Dispose of used batteries properly and keep them out of the reach of the children.

FCC Regulation

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. This equipment, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Any changes or modi cations not expressly
approved by the manufacturer could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures: reorient
or relocate the receiving antenna; increase the separation between the equipment and receiver; connect the
equipment into an outlet on a circuit different from that to which the receiver is connected; consult the dealer or
an experienced radio/TV technician for help.
B
FF
GG
9
KK
HH
GG
Please contact 1-877-527-0313 for further assistance.
II
JJ
HOMEDEPOT.COM/ECOSMART