Settings And Adjustments - New Comfort CA3500 Instruction Manual

SETTINGS AND ADJUSTMENTS

2. Ozone Control

The Ozone control can turn on, off or adjust ozone function without
degrees.

To reduce the level of Ozone, user may also remove one of the Ozone
plates.

To reduce mold, mildew, and bacteria, turn the unit on the highest setting
for 3-4 hours. Open doors and windows to allow air to circulate out of the
room.

The POWER light turns to GREEN when the "Fan" switch is turned on. The
OZONE light turns to RED when the "Ozone" switch is turned on. Only run
the Ozone feature in unoccupied spaces. After the Ozone feature is turned
off, allow one hour before reoccupying the room.

Do not look at front panel in close proximity or stare at the UV light.
Always ensure the room or area is UNOCCUPIED
before performing the above-described Ozone control.
7
1. Control of the Unit
When looking at the front of the
unit, the controls for UV,
Ionization, Fan Speed are
located on the right. The knob
on the left controls the Ozone.
This allows using the New
Comfort as a standard air
purifier (no Ozone but pulling
air through the 5 stages of
filtration) or to use all 6 stages
(Ozone included).
CAUTION!