SmartLock LOCK-ONE Technical Manual

LOCK-ON E T ECHNICA L MA NUAL

Default codes (change default codes)

Setup (Master)
Service
Manager
Users (1-9)

Open the lock

• Enter the code and open within 4 seconds.
• If time delay is set wait for counting: an acoustic signal indicates open window.
• Enter the code and open within 4 seconds.
Open the lock with time delay override
• Enter override user (9) code.
• Enter second code and open within 4 seconds.
If lock is already counting time delay enter override user (9) code to immediately open.

Change code (door open)

• Press and hold 0 until double beep: enter old code.
• Enter and confirm new code.

Install a user

• Press and hold 1 until double beep: enter Manager code.
• Enter user ID (1-9).
• Enter and confirm new user code.
To install Manager enter the function with Service code.

Users management

• Press and hold 2 until double beep: enter Manager code.
• Press P to scroll users list and check their status.
• Press 1 to install a user: enter and confirm user code.
• Press 2 to disable/enable a user.
• Press 3 to delete a user.
• Press OK to confirm and exit.

Delete a user

• Press and hold 3 until double beep: enter Manager code.
• Enter user ID (1-9).
To delete Manager enter the function with Service code.

Test function

• Press and hold 5 until double beep.
• Enter the sequence: 1-2-3-4-5-6-7-8-9-0.
• Double beep: key properly working. Long beep: key malfunction.
If lock and keypad don't communicate display shows the message: NO ANSWER.

Audit

• Press and hold 7 until double beep and enter Manager code or access Setup menu
and press 7.
• Display shows last opening/closing operation.
• Press 1 to check next event, press 0 to check previous event.
• Press OK to exit.
5-0-5-0-5-0-5-0
not installed
1-2-3-4-5-6
not installed
CODE
o o o o o o
OPEN
LOCK
CHANGE
o o o o o o
INSTALL
o o o o o o
ID= 1
ID= 2
ID = 3
DELETE
o o o o o o
TEST
ID=1 16:30
16/07/17
ID= 16:31
16/07/17
1 of 3