Kalorik VC 42475 Operating Instructions Manual page 7

Fax +1 305 430 9692

2. Charge on base
 Place the base on a flat, horizontal, stable surface that is not
exposed to direct sunlight or humidity, and far from any heat
source.
 Remov e the rubber cover on the base to access the charging
pins on top of the charging station.
 Make sure the appliance is set to off, and all the accessories are
remov ed.
 Plug the charger into the side of the base, and then plug it into a
w all socket.
 Place the battery into the charging base, making sure that the
connection pins on the base are straight and not crooked. The
battery should insert perfectly into the base
 The LED light on the base lights up red, and w ill start blinking, to
show that the battery is charging.
 When the battery is fully charged, the LED indicator light should
glow solid red (it w ill no longer blink).
Note: To remov e the battery from the base, simply press the 2
buttons on each side of the battery and lift it out from its cradle.
Note: We recommend keeping your appliance alw ays in charge
w hen not in use, this w ay it w ill keep a full charge and w ill alw ays be
ready for use w hen you need it.
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International USA.
The pages must be reproduced and folded in order to obtai n
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numberi n g.
Keep the language integrity.
7
Assembly page 7/32
Print only what is inside the frame.
VC 42475 - 160909