LEGRAND Raritan Dominion LX II Quick Setup Manual

Dominion® LX II
DLX2-108
DLX2-116
DLX2-216
Thank you for choosing the Dominion LX II switch,
or Dominion LX II integrated switch/LED drawer,
designed for economical, reliable and secure
remote access and management. This Quick Setup Guide explains how to install and configure your LX II.
These second-generation KVM-over-IP switches and integrated switch / LED drawer models give one/two remote users and one
local user, Java-free, BIOS-level access and control of 8 or 16 servers. Optional management of 2 to 8 serial devices is also available.
Standard productivity features such as virtual media, absolute mouse synchronization, directory server authentication, and PC
Share are all included.
Package Contents
 Switch-only models: DLX2-108, DLX2-116, DLX2-216
• 1 - LX II switch-only device
• 1 - Rackmount kit
• 1 - AC power cord
1 - Set of 4 rubber feet for desktop use
•
 Integrated switch/LED drawer models: DLX2-108-LED,
DLX2-116-LED, DLX2-216-LED
• 1 - LX II integrated switch/LED drawer device
• 1 - Rackmount kit with sliding rails
• 1 - AC power cord
QS Rule
• Operation temperature in a closed rack environment may be
greater than room temperature. Do not exceed the rated
maximum ambient temperature of the appliances. See
Specifications in Administrators Guide.
• Ensure sufficient airflow through the rack environment.
• Mount equipment in the rack carefully to avoid uneven
mechanical loading.
• Connect equipment to the supply circuit carefully to avoid
overloading circuits.
• Ground all equipment properly, especially supply connections,
such as power strips (other than direct connections), to the
branch circuit.
QS Rule
Rack Mounting - Switch-Only Models - DLX2-108,
DLX2-116, DLX2-216
LX II switch-only models can be mounted in 1U (1.73", 44 mm) of
vertical space in a standard 19" equipment rack, facing the front of
the rack or facing the rear of the rack.
Use the brackets and screws shipped with the device.
Dominion LX II Quick Setup Guide
QSG-DLX2-v3.0.0-0B-E  255-62-0024-00
DLX2-108-LED
DLX2-116-LED
DLX2-216-LED
Forward Mount - Switch-Only Models - DLX2-108,
DLX2-116, DLX2-216
Numbered steps correspond to the numbers in the diagram.
1. Secure the cable-support bar to the back end of the side
brackets using two of the included screws.
2. Slide the LX II between the side brackets, with its rear panel
facing the cable-support bar, until its front panel is flush with
the "ears" of the side brackets.
3. Secure the LX II to the side brackets using the remaining
included screws (three on each side).
4. Mount the entire assembly in your rack and secure the side
brackets' ears to the rack's front rails with your own fasteners.
5. When connecting cables to the rear panel, drape them over the
cable-support bar.
QUICK SETUP GUIDE
1