Operating Sequence; Washing; Load The Laundry; Measure Out The Detergent - Zanussi ZWD 1682 W Instruction Booklet

Operating Sequence

WASHING only
Before the first wash we recommend that you run a
cotton cycle at 95°C, without any laundry in the
machine to remove any manufacturing residue from the
drum and tub.
Pour 1/2 a measure of detergent into the main wash
compartment of the dispenser drawer and start up
the machine.

1.Load the laundry

Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.

2.Measure out the detergent

Pull out the dispenser drawer until it stops. Measure out
the amount of detergent required and pour it into the
main wash compartment
If you wish to carry out the prewash phase, pour
detergent into the appropriate compartment marked
3.Measure out the fabric
softener
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
Close the drawer gently.
.
4. Select the required
programme/fabric
Turn the programme selector dial to the desired position
to switch the appliance on, the lights corresponding to
the different phases making up the selected programme
light on. To switch the appliance off turn it to Off.
The "Start/Pause" button light flashes. The display
shows the duration of the programme.

5. Select the temperature

Press the "Temp." button if you wish to select a
temperature value different from the one proposed by
the washing machine.
.
6. Select the spin speed or the
Rinse Hold option
Press the "Spin Speed" button repeatedly, in order to
select the desired spin speed or the "Rinse Hold" option
. The relevant light will light up.
If you select the "Rinse Hold" option, the machine will
stop at the end of the programme with the water still in
the tub.
10