Personnel Qualification - bar agturn PKT Series Operating Manual

Use head protection!
Wear suitable head protection
during transport.
Use protective clothing!
Wear suitable protective clothing
during commissioning, mainte-
nance and troubleshooting.
Use hand protection!
Wear suitable hand protection
during transport, commissioning,
maintenance and troubleshooting.
• Instructed persons must operate the rotary actuator and be able to detect possible
damage and dangers on the rotary actuator.
• Instructed persons with technical training must also be aware of the dangers of han-
dling pressurized equipment, hot and cold surfaces, harmful and hazardous materials
and the process of installing and removing the valves in a process line, the specific and
potential risks of the process and the most important safety regulations.
• Trained electricians must read and understand electrical circuit diagrams, commission,
put electric machines into operation, service and maintain them, wire switch and control
cabinets, install control software, ensure the functionality of electrical components and
identify potential hazards in handling electrical and electronic systems.
• Trained pneumatic specialists must read and understand pneumatic circuit diagrams,
put pneumatic systems into operation, service and maintain them, disconnect and
connect pneumatic hoses, ensure the proper functioning of pneumatic components,
assess the work performed on the pneumatic system and identify potential hazards.
PKT-GD/GS-IM-DE-B-EN-09-19 Rev.0
2.6

Personnel qualification

Only trained or instructed personnel who
has known and understood the operating
instructions as well as the possible dangers
of the rotary actuator is allowed to work with
the rotary actuator. The responsibility of the
personnel for operation, maintenance and
repair must be clearly defined by the oper-
ator.
Personnel to be trained, instructed or un-
dergoing training may work on the rotary
actuator only under the constant supervi-
sion of an experienced person.
The individual activities on the rotary actua-
tor require different personnel qualifications
which are listed in the following table. The
different qualifications are characterized by
the following skills and knowledge:
9