Table of Contents
Advertisement
Quick Links
1.0 SAFETY INFORMATION
•
The provision of the electrical supply and the connection of the unit to the electrical supply
must be carried out by a qualified electrician in accordance with latest edition of the wiring
regulations.
•
Isolate from power supply before removing any covers. During installation / maintenance ensure
all covers are fitted before switching on the mains supply.
•
All-pole disconnection from the mains as shown in the wiring diagram must be incorporated
within the fixed wiring and shall have a minimum contact separation of 3mm in accordance with
latest edition of the wiring regulations.
•
Ducting must be securely fixed with screws to the spigot to prevent access to live parts. Duct
runs terminating close to the fan must be adequately protected by suitable guards.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard. The replacement cord must be of the same
technical specification as the original cord or greater.
•
Precautions must be taken to avoid the back-flow of gases into the room from the open flue of
gas or other fuel-burning appliances.
•
This appliance should not be used by children or persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, unless they have been given supervision
or instruction concerning the safe use of the appliance by a person responsible for their safety.
Children shall not play with the appliance. Cleaning and user maintenance shall not be carried
out by children.
1.1 Hazard Symbols
GENERAL WARNING
Signifies a general warning regarding hazard specified by supplementary information.
ELECTRIC SHOCK
This unit must be completely electrically isolated before any panels are removed. Check
mains supply and control connections.
REFER TO INSTRUCTION MANUAL
Read and understand the installation and maintenance manual before installing,
operating or maintaining this product.
Nuaire |
Western Industrial Estate
ES-OPUSDC
Low Power Duct Mounted Extract Fans
Installation Manual
|
|
| nuaire.co.uk
Caerphilly
CF83 1NA
06. 10. 20. Document Number 671139
EMC Directive
2014/30/EU
LVD Directive
2014/35/EU
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for NuAire ES-OPUSDC Series
Summary of Contents for NuAire ES-OPUSDC Series
- Page 1 This unit must be completely electrically isolated before any panels are removed. Check mains supply and control connections. REFER TO INSTRUCTION MANUAL Read and understand the installation and maintenance manual before installing, operating or maintaining this product. Nuaire | | nuaire.co.uk 06. 10. 20. Document Number 671139 Western Industrial Estate Caerphilly...
-
Page 2: Personal Protective Equipment
2.0 INTRODUCTION Installation must be completed by competent persons, in accordance The Nuaire range of low power duct mounted extract fans have been with good industry practice and should conform to all governing and specifically designed to ventilate areas such as toilets, bathrooms, small statutory bodies i.e. -
Page 3: Typical Installation
. Air extract from Control panel Flexible ducting WC for example. available as an Grille available as optional extra. an optional extra. Nuaire | | nuaire.co.uk 06. 10. 20. Document Number 671139 Western Industrial Estate Caerphilly CF83 1NA... -
Page 4: Electrical Installation
Mains Cable, Clamp and PCB's Fan 1 Fan 2 Min Max Run On Pwr Standby Fan 1 Fan 2 Switch to activate continuous trickle Nuaire | | nuaire.co.uk 06. 10. 20. Document Number 671139 Western Industrial Estate Caerphilly CF83 1NA... -
Page 5: Wiring Diagrams
The volt free contacts are not fused. If these are used to power any external equipment, the installer must provide adequate fusing or other protection. These contacts are rated at 5A resistive, 0.5A inductive. Nuaire | | nuaire.co.uk 06. 10. 20. Document Number 671139... -
Page 6: Warranty
Please call After Sales Support for further information on items not listed above. Ensure that Nuaire product is made safe from any electrical / water / refrigerant supplies before dismantling commences. This work should only be undertaken by a qualified person in accordance with local authority regulations and guidelines, taking into account all site based risks. - Page 7 fixed installation detail Nuaire to be assembled into a ventilation system which may or may not include (eg ducting), then guarding to the appropriate standard must be fitted.
- Page 8 ES-OPUSDC Installation Manual NOTES Nuaire | | nuaire.co.uk 06. 10. 20. Document Number 671139 Western Industrial Estate Caerphilly CF83 1NA...
Need help?
Do you have a question about the ES-OPUSDC Series and is the answer not in the manual?
Questions and answers