Advertisement
3． Installing the Dust-proof Bezel to the Server
Take the steps below to install the dust-proof bezel to the server.
< Important>
●Read the sections "Safety Precautions" and "Handling precautions" in the User's Guide of the server in
which you are going to install the dust-proof bezel to install the dust-proof bezel safely and properly.
Note: The outer dimension of the server is as follows after the bezel is installed.
98.0 mm (Width) × 415.7 mm (Depth) × 347.1 mm (Height) (With air duct, stabilizers, and projection excluded)
200.0 mm (Width) × 447.5 mm (Depth) × 347.1 mm (Height) (With air duct, stabilizers, and projection included)
1. Power off the server, and disconnect the power cord.
2. Lay down the server. Slide the side cover toward rear of the server (①in the figure) while pushing the
two eject buttons on the side cover, and lift the side cover as shown ②in figure , then remove the side
cover.
Eject Button
Slide the side cover in the
direction shown by an arrow.
①
③
23
Lift the side cover as shown
in figure, then remove the
side cover.
②
Advertisement
