PSR-E443
2.
AMJK Circuit Board
(Time required: About 3 minutes)
2-1
Remove the lower case assembly. (See procedure 1.)
2-2
Remove the eight (8) screws marked [380A] and two
(2) screws marked [380A-2] that installed DC circuit
board. The AMJK circuit board can then be removed.
(Fig.2)
*
As for the screw marked [380A] at the location of
"A", it is tightened together with a wire clip. (Fig.2)
*
When installing the AMJK circuit board, tighten
the screws 1, 2 in that order and then the
remaining screws. (Fig. 2)
右
3.
MVR Circuit Board
(Time required: About 3 minutes)
3-1
Pull out the volume knob from the control panel as shown
in Fig.3. (Fig.1, Fig.3)
3-2
Remove the lower case assembly. (See procedure 1.)
3-3
Remove the three (3) screws marked [380B]. The MVR
circuit board can then be removed. (Fig.2)
4.
ENC Circuit Board
(Time required: About 3 minutes)
4-1
Pull out the encoder knob from the control panel as shown
in Fig.4. (Fig.1, Fig.4)
4-2
Remove the lower case assembly. (See procedure 1.)
4-3
Remove the three (3) screws marked [380C]. The ENC
circuit board can then be removed. (Fig.2)
10
(下から見た図)
(フック(A))
スピーカ (ツイーター)
(下ケース鍵盤Ass'y)
右
2.
AMJK シート(所要時間 : 約 3 分)
2-1
下ケース Ass'y を外します。 (1 項参照)
2-2
[380A] のネジ 8 本および [380A-2] の DC-IN シート
取付ネジ 2 本を外して、 AMJK シートを外します。
(図 2)
※
A の位置の [380A] のネジ 1 本は、束線止めと共
締めされています。 (図 2)
※
AMJK シートを取り付けるときは、1、2 の順でネ
ジを締めてから他のネジを締めてください。( 図 2)
(フック(A))
左
Fig.2 (図 2)
3.
MVR シート(所要時間 : 約 3 分)
3-1
コントロールパネルから、V ツマミを図 3 のよう
にして抜いておきます。 (図 1、図 3)
3-2
下ケース Ass'y を外します。 (1 項参照)
3-3
[380B] のネジ 3 本を外して、MVR シートを外しま
す。 (図 2)
4.
ENC シート(所要時間 : 約 3 分)
4-1
コントロールパネルから、エンコーダツマミを図 4
のようにして抜いておきます。 (図 1、図 4)
4-2
下ケース Ass'y を外します。 (1 項参照)
4-3
[380C] のネジ 3 本を外して、 ENC シートを外します。
(図 2)
スピーカ (ツイーター)
左